Continuous Waterfall; Electrical Installation - Aquatic iNfiNity serIes Owner's Manual & Installation Manual

iNSTALLATiON iNSTruCTiONS
CONTiNuOuS WATErFALL (iNFiNiTy 1):
the infinity 1 is equipped with a continuous waterfall that is powered by a recirculation pump. the recirculation pump
is plugged into your maintenance heater (see Diagram 4A, pg. 13). The maintenance heater must be plugged in for the
continuous waterfall to be operational (see Diagram 4A, page 13). See page 15 for operation instructions.

ELECTriCAL iNSTALLATiON:

WArNiNg: ALL ELECTrICAL CONNECTIONS SHOULD BE MADE BY A LICENSED, LOCALLY CErTIFIED
ELECTrICIAN, IN ACCOrDANCE WITH THE rEqUIrEMENTS OF THE NATIONAL ELECTrICAL CODES AND
PROCEDURES.
WARNiNg: WHEN USING ELECTrICAL PrODUCTS, PrECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING
tHE fOLLOWiNg:
dANgEr: riSK OF ELECTriC ShOCK!
infinity baths will need to be hard wired to the outlets provided. See the following directions and diagram.
two junction boxes will be mounted to the frame of the whirlpool. One of the two boxes will have one outlet and will be
labeled "Blower". remove the cover and connect a 14/2 with ground romex wire from a 15 amp 1-pole GFCI breaker
(not supplied) in the main circuit breaker panel. Connect the black wire to the hot side of the receptacle, the white
wire to the neutral side of the receptacle and the green wire to ground. Replace the cover and plug in the blower. (See
diagram on page 12).
The second junction box will have two outlets, one labeled "Main" and the other labeled "Heater". remove the cover.
Run Romex 14/3 with ground from a 15 amp 2-pole gfCi breaker (not supplied) located in the breaker panel. Connect
the white wire (neutral) to both neutrals of the two outlets. Connect the red wire (hot) to the hot terminal of the outlet
labeled "Main". Connect the black wire (hot) to the hot terminal of the other outlet labeled "Heater". Connect the green
wire (ground) to the ground terminal of the outlet. Replace the cover of the junction box. find the cord labeled "Heater
AC Input" and plug it into the outlet labeled "Heater". Plug the cord labeled "Main AC Input" into the outlet labeled "Main".
Both of these cords will come from the right side of the heater and will be marked. (See diagram on page 12).
aquatic Industries, Inc.
gFCi's are not supplied, however we do specify their use.
All known code authorities require gFCi's.
11