Table of Contents
Advertisement
iNSTALLATiON iNSTruCTiONS
FACTOry iNSTALLEd TiLE FLANgE:
SEE iLLuSTrATiON 2A
A. install the whirlpool bath unit per the instructions provided in this manual.
CAuTiON: ThE TiLE FLANgE dOES NOT SuPPOrT ThE TuB! A ledger board must be provided under the
bath rim as indicated in the installation instructions. Take care to ensure tub is not hanging from the ledger boards,
as this will void your warranty.
B. Use nails or screws to secure the flange into the studs around the bath.
C. install water resistant drywall against the tile flange and flush to the top of the whirlpool deck. install the tile or other
finishing materials. Apply a second bead of silicone between the first course of tile and the bath deck.
NOTE: Before tub is used, the whirlpool system should be cleaned in accordance
PLuMBiNg:
1. After securing tub in place, normal waste and overflow and valves (3/4" valves are recommended) are installed per
normal plumbing procedures, in accordance with all state and local standards.
2. Install standard 1-1/2" trap to drain and overflow. Before proceeding, make a final operational check by filling tub
with water to overflow and operate pump for 5 minutes. Check for leaks carefully both while pump is running and
has been turned off. Allow water to stand in tub for at least 30 minutes before draining. AquATiC iNduSTriES,
iNC. WiLL NOT BE rESPONSiBLE FOr WATEr dAMAgE OF ANy KiNd iN CONNECTiON WiTh ONE OF Our
WhirLPOOL BAThS.
3. All Infinity Series models are equipped with an integral Fast Fill Waterfall Spout. Purchasing a spout is unnecessary,
however, hot and cold water valves are needed. Valves can be mounted where you choose, however, if installation
is to be on the tub deck, check the back side of the tub for adequate space for connection to water lines before
drilling or cutting tub.
aquatic Industries, Inc.
2A
with the procedures on Page 22 of this manual.
9
Hide quick links:
Advertisement
Table of Contents
