Leveling Of The Infinity I - Aquatic iNfiNity serIes Owner's Manual & Installation Manual

iNSTALLATiON iNSTruCTiONS
STruCTurAL PrEPArATiON (continued):
5. When placing the tub on a platform or cut out (see Diagrams), the opening should be 1" smaller than the specified
rim dimensions. Extreme care must be taken in this type of installation to ensure the tub will come to rest entirely on
the leveling feet.
6. iF yOu hAVE PurChASEd A WhirLPOOL WiTh AN iNSTALLEd TiLE FLANgE, PrOCEEd TO iNSTruCTiON "2A".
LEVELiNg OF ThE iNFiNiTy 1:
1. With a six foot level, level whirlpool left to right (see Diagram 1F). Make sure that the level is placed on the flat surface
of the whirlpool, and not resting on the hump of the backrest or the tile flange.
2. Next, level the whirlpool front to back (see Diagram 1G). Put one end of the level on the center of the recirculating
discharge screen and the other end on the front lip of the whirlpool. Place a 3/8" spacer between the level and the
front lip of the whirlpool.
3. After leveling the front to back of the whirlpool, check the left to right level. If not level, re-adjust until level. Check
again until left to right and front to back are both level.
8
1F
1g
A d d 3 / 8 " S p a c e r
underneath Level
aquatic Industries, Inc.