Electrolux TC2 Service Manual page 61

Alarm
E95 PCB faulty.
E97 Faulty PCB (Wrong configuration data).
E98 Incompatibility between main board and Inverter.
E9B Display board.
E9C Display board.
E9D Display board.
E9F
Main board.
EH1
Power supply problems (incorrect / disturbance); PCB faulty.
EH2
Power supply problems (incorrect / disturbance); PCB faulty.
EH3
Power supply problems (incorrect / disturbance); PCB faulty.
EHE Wiring faulty; PCB faulty.
EHF
PCB faulty.
EC1 Solenoid valve faulty/blocked; PCB faulty.
EC3
Wiring faulty; Weight sensor faulty; PCB faulty.
ED1
Wiring faulty between PCB and WD board, WD board faulty, PCB faulty
ED2
Wiring faulty between WD board and thermostats, WD board faulty, PCB faulty.
ED3 Wiring faulty between WD board and thermostats, WD board faulty, PCB faulty.
ED4
Wiring faulty, WD board faulty, PCB faulty.
Drain tube blocked/kinked/too high;
EF1
Drain filter dirty/blocked.
Excessive detergent dosing; drain tube kinked/blocked;
EF2
Drain filter dirty/blocked.
EF3 Water leaks onto base frame; water control system defective.
EF4 Tap closed, water pressure too low.
EF5 Load too unbalanced, Final spin phases skipped.
E00
SOI/DT 2007-06 dmm
Possible fault
----------------
61/75
Action/machine status
Cycle interrupted.
Cycle interrupted.
Cycle interrupted.
Cycle interrupted.
Cycle interrupted.
Cycle interrupted.
Cycle interrupted.
Wait for frequency nominal conditions.
Wait for voltage nominal conditions.
Wait for voltage nominal conditions.
Safety drain cycle – Cycle stopped with
door open.
Safety drain cycle – Cycle stopped with
door open.
Cycle interrupted with door closed.
Drain pump functions always (5 min.,
then it stops for 5 min. etc.).
----------------
Cycle interrupted.
Cycle interrupted with door open.
Cycle interrupted with door open.
Cycle interrupted with door open.
Warning displayed at the end of cycle
(specific LED).
Warning displayed after 5 attempts or by
the specific LED.
Machine drains and cycle stops.
---------------------------
----------------
----------------
Reset
RESET
RESET
OFF/ON
ON/OFF RESET
ON/OFF RESET
ON/OFF RESET
OFF/ON
OFF/ON
OFF/ON
OFF/ON
RESET
RESET
RESET
START/RESET
OFF/ON
RESET
RESET
RESET
START/RESET
RESET
ON/OFF RESET
RESET
RESET
----------------
599 38 94-46