Electrolux TC2 Service Manual page 10

•
LED wash phase indicators:
The LEDs L13, L12, L16 are configurable and are used as indicators of the
wash phases
Pre-wash
Wash
Pre-wash/Wash
Rinses
Spin
Rinses / Spin
Drain
Extra rinse
Rinse-hold
Current cycle
End of cycle
Door locked
Child lock
•
Display
The following information appear on the display:
- The duration of the washing programme, which appears after
having selected it. This time corresponds to that necessary for the
maximum wash load for each programme type. After starting the
programme the time decreases minute by minute.
- The end of the programme is indicated by three zero flashing
(when it is possible to open the door).
- The stop of the appliance with water in tub, after the programmes
with RINSE HOLD option, is displayed by three zero flashing. The
LED that indicates the door remains lit and the LED of the
START/PAUSE button switches off.
- The delayed start, selected through the relative button. After
pressing the START/PAUSE button the countdown starts and the delay
time decreases hour by hour. In the last 2 hours it diminishes by 30
min.
- The thermometer: it is always on during the cycle and the icon is
animate during the heating phase.
SOI/DT 2007-06 dmm
Indications
Lights during selection mode if the programme includes the pre-wash phase,
and during the execution of the pre-wash
Lights during selection mode if the programme includes the wash phase, and
during the execution of the wash
Lights during selection mode if the programme includes the pre-wash or wash
phases, and during the execution of these phases
Lights during selection mode if the programme includes rinse phases, and
during the execution of the rinses
Lights during selection mode if the programme includes the spin phase, and
during the execution of the spin
Lights during selection mode if the programme includes rinses and spin and
during the execution of these phases
Lights during selection mode if the programme includes the drain phase, and
during the execution of the drain
Lights when this option has been memorized (if included in the cycle)
Lights if the programme includes the rinse-hold option and at the end of the
cycle, when the appliance stops with water in the tub
Lights during execution of the cycle
Lights when the programme has been completed; also used to display alarm
conditions
Lights when the door lock prevents opening of the door, and switches off when
the door can be opened. Flashes when the interlock is about to release the
door (may be seen if PTC devices are used, as these require one or two
minutes before releasing the lock)
Lights when the child safety is on and all buttons are deactivated
10/75
599 38 94-46