Working With An Imagebank-Ii - Hasselblad H3D 31MPix User Manual

1
3
2
4
Removing a card
1. Open the CF card slot cover on the sensor unit. Behind the
cover, you can see the bottom edge of the card in its slot and
a release button immediately below the card.
2. Press the release button a little way in to release it into the
active position.
3. Press the now extended release button all the way back into
the sensor unit again. Some force is required. As you do this,
the card will be pushed out a few millimeters.
4. Grasp the card between your thumb and forefinger and pull it
away from the sensor unit. (Insert a new card as described in
"Inserting a Card", if required).
5. Snap the slot cover shut again.
Working with an ImageBank-II
There are no practical differences between storage on the internal
CF card or on an ImageBank-II. However, when several media
are mounted, you must be sure to select the correct destination
medium (see also "Working with Media and Batches").
Working with a Hasselblad ImageBank-II
The ImageBank-II is an optional add-on for your digital camera
system. It is essentially an external FireWire hard disk optimized
for digital photography, providing extensive storage space and
high-speed data transfer. It is small, light and battery powered. You
can easily clip it to your belt, so the solution is nearly as portable
as the stand-alone camera.

Older digital backs in the 'ixpress' line used a different external
disk and controller called simply the "ImageBank". This older
version is not compatible with the H3D. Only use the Hasselblad
ImageBank-II with an H3D.
To use an ImageBank-II with the H3D, simply assemble it as
described in its manual and connect the two with a standard
FireWire 800 (IEEE 1394b) cable. See the ImageBank-II manual
for complete details.
To remove the ImageBank-II, simply disconnect the FireWire
cable. The back will then revert to saving and browsing images
on the internal flash card (if available).
37