Outside Air Boot Installation (Part Number 99200134) - Lopi Endeavor Owner's Manual

37
Outside Air Boot Installation
The outside air boot routes outside air to the stove for combustion. Refer to the section "Outside Air
Requirements" for installation concerns. The directions below detail installation.
1 Install the cover plate following the directions below (use the cover plate that is 6-1/2" wide). The
cover plate prevents combustion air from entering the front of the stove.
Remove the two screws on the
cover plate to remove the piece that
fits over the air control rod. Then
replace the piece when the cover
plate is in place.
2 Refer to the illustration below to determine the location and size of the hole penetrating the floor
and hearth. The knock-out (which is pre-removed) is 6-3/8" behind the face of the stove - it is 8"
wide and 4-1/4" deep. Cut the hole prior to locating the stove.
3 Attach gasket to the bottom edge of the lower air boot section (near the screen). Attach gasket
on top of the flanges on the upper air boot section. Slide the two sections together with both
seams facing the rear (do not attach the two sections at this time).
4 Follow the directions below for attaching the upper section of the air boot (with gasket) to the
stove.
5 Slide the lower section down until it contacts the hearth. Attach the two sections together
following the directions below
Attach the included
gasket to all four top
edges of the air boot.
© Travis Industries
(Part number 99200134)
Attach gasket to the bottom
edge of the air boot.
Floor (and hearth)
Index
The cover plate has a clip which attaches
it underneath the air control.
Bottom of Stove
Attach the air boot with
the two screws included
with the kit.
Use the included screws to attach
the two telescoping portions of air
boot together. The included drill bit
5-1/8"
should be used to drill the hole.
Make sure the air boot is expanded
8-7/8"
to the correct size before drilling.
9/64" Drill Bit
The hole in the floor (and hearth)
must be a minimum 16 square
inches. It should be 1/2" smaller
than the footprint of the air boot in
each dimension to allow for the
gasket to seal.
100-01334
Air Control Rod
Use a
screwdriver to
pry out the
knock-out.
1/4" Nutdriver
5/16" Nutdriver
4131122