Quick-Start Demo - Teknetics G2 Owner's Manual

QUICK-START DEMONSTRATION
I. Supplies Needed
• a Nail
• a Nickel
II. Position the Detector
a. Place the detector on a table,
with the searchcoil hanging over
the edge.
Or better, have a friend hold the
detector, with the searchcoil off
the ground.
b. Keep the searchcoil away from
walls, floors and metal objects.
c. Remove watches, rings and
jewelry.
d. Turn off lights or appliances,
whose electromagnetic emissions may cause interference.
e. Pivot the searchcoil back.
III. Click on detector with the left knob. Set the Gain at the
12:00 position for this demonstration.
IV. Click the right knob to the left to the DISC setting.
V. a. Wave the nail over the searchcoil.
+
b. Press
• Notice the change in sound.
• Sound changes from a HIGH tone to V.C.O. tones (see
page 25).
VI. Wave each object over the searchcoil.
Sweep coin flat and parallel to the searchcoil. This is how
you will usually find them buried.
a. Notice the tones and 2-digit target IDs for each object.
b. Motion is required.
Objects must be in motion over the searchcoil to be
detected in this mode.
+
VII. Press the
=
display 60.
VIII. Wave the nail over the searchcoil.
a. The nail will not be detected
b. The nail has been "discriminated out."
8
• a Zinc Penny (dated after 1982)
• a Quarter
repeatedly, while continuing to wave the nail.
button several more times until the Disc value on the
Quick-Start Demo continued on next page