Quick-Start Demo - Teknetics G2+ Owner's Manual

QUICK-START DEMONSTRATION
• a Nail
I. SuppliesNeeded
• a Nickel
a. Place the detector on a
II. PositiontheDetector
table, with the searchcoil
hanging over the edge. Or
better, have a friend hold
the detector, with the
searchcoil off the ground.
b. Keep the searchcoil away
from walls, floors and
metal objects.
c. Remove watches, rings and jewelry.
d. Turn off fluorescent lights, appliances and cell phones
whose electromagnetic emissions may cause interference.
e. Pivot the searchcoil back.
III. Click on power with the left knob. Set the Gain at the 12:00
position for this demonstration.
IV. Click the right knob to the left to the DISC setting.
Press
a. Press
V.
b. Wave the nail over the searchcoil. Notice volume.
c. Wave a coin over the searchcoil. Notice louder volume.
d. Enter the menu/volume control again.
Use
searchcoil. Notice the volume changing.
VI. a. Set volume at 20. Wave the nail over the searchcoil.
b. Press
c. Press
The nail will be discriminated out. The Target-ID at which it is eliminated
depends on the size of the nail.
Sweep coins flat and parallel to the searchcoil. This is how
VII. Waveeachobjectoverthesearchcoil.
you will usually find them buried.
a. Notice the 2-digit Target-IDs for each object.
b. Motion is required.
Objects must be in motion over the searchcoil to be
detected in this mode.
8
• a Zinc Penny (dated after 1982)
• a Quarter
until "VOLUME" is highlighted on display.
or until number on display is 12.
and to change volume as you wave nail over
until DISC is highlighted on display.
repeatedly, while continuing to wave the nail.
Quick-Start Demo continued on next page