Teknetics G2 Owner's Manual page 19

OPERATING IN DISCRIMINATION MODE
In Discrimination mode, pressing
1. Tone Identification
2. Target Elimination
As the level of discrimination changes, the target segments along the arc on the
screen will be displayed in one of three states:
1. Blank (no segments displayed)
2. Grey (segments displayed in a shaded color)
3. Black (segments are solid black)
The segments along the arc will remain illuminated in this state as you are
+ –
pressing or
This displays your chosen target discrimination parameters.
At any time during operation, you can view the discrimination settings in one of
two ways:
1. On the bottom-right of the screen the DISC value is always illuminated.
a. This value is the division between the LOW tones and V.C.O. tones.
b. This value is the lowest target value which will be detected with a
V.C.O. tone.
2. Whenever you press
current detection parameters.
The first press of
When a target is detected, the rectangular segments representing the target
category are illuminated.
.
+
–
+
or
+ –
or will change two detection parameters:
–
or , the arc will illuminate and show your
will change the discriminate level by one value.
Discrimination Control continued on next page
19