Touchpad Controls; Gg / Pinpoint; And - Teknetics G2 Owner's Manual

CONTROL PANEL
GAIN versus THRESHOLD
"Gain" increases, or multiplies, the strength of signals from buried metal objects.
For maximum detection of the smallest or most deeply buried objects, increase
the Gain. To minimize the weakest signals, reduce the Gain.
"Threshold" controls the detector's audio level. Positive threshold values
amplify the audio response of weak target signals. Negative threshold
values suppress sensitivity.
For searching at maximum sensitivity
set threshold into the positive region, with a comfortable background-hum
volume level. Then increase Gain to a comfortable level, free of chatter.
For silent searching, set threshold to a negative number, and also reduce
Gain if necessary. Silent searching will result in the loss of some sensitivity.

TOUCHPAD CONTROLS

1. GG / PINPOINT

This button has a dual function, depending on the detection mode.
a. In DISC mode, press-and-hold the button to activate PINPOINT.
Pinpoint temporarily engages a no-motion detection mode. Searchcoil
motion is not necessary to detect metal. Any metal within the searchcoil's
detection field will induce a sound. Pinpoint is generally used to verify a
target previously detected in Discrimination mode.
b. In ALL-METAL mode, press-and-hold the button to activate GROUND GRAB.
Ground Grab allows you to set the detector's internal ground setting equal
to the phase of the ground you are searching over. See the section on
Ground Balancing for a more thorough explanation of this feature and the
reason for using it.

2. + and -

a. In Discrimination mode,
rejection)
b. In All-Metal mode,
Setting.
14
+ -
and change the level of discrimination (target
+ -
and provide a manual override to the Ground Balance
, first set the gain at a low level. Then