Table of Contents
Advertisement
QUICK-START DEMONSTRATION
I. Supplies Needed
• a Nail • a Gold Ring (try several different size gold rings) • a Large Silver Coin
II. Position the Detector
a. Place the detector on a table, with the searchcoil hanging over the edge.
Or better, have a friend hold the detector, with the searchcoil off the ground.
b. Keep the searchcoil away from walls, floors and metal objects.
c. Remove watches, rings and jewelry.
d. Turn off lights or appliances, whose electromagnetic
emissions may cause interference.
e. Pivot the searchcoil back.
III. Power Up
Press
IV. Wave each object over the searchcoil
a. Notice the tones and Target-IDs for each object (assumes default DISC
setting):
OBJECT
Nail
Gold Ring
Larger Gold Ring
Silver Coin
b. Motion is required.
• Objects must be in motion over the searchcoil to be detected.
• Sweep objects flat over the searchcoil, parallel to the plane of the searchcoil.
V. Press
twice to activate the DISC selection
a. While sweeping the Nail back-and-forth, press
increase the DISC setting.
b. Continue to press
• Notice that the Nail is eliminated from detection when the DISC setting is
equal to the target's ID.
Caution: Passing the nail at differing angles will yield different ID numbers.
VI. Repeat Step V while waiving the Gold Ring, and then also
while waiving the Silver Coin
.
TARGET-ID
lower (e.g. 10-35)
medium (e.g.- Mid 50's)
medium (but higher than ID for smaller gold ring)
higher (e.g.- 80-99)
and increase the DISC setting.
TONE
V.C.O.
V.C.O.
V.C.O.
High
to
7
Advertisement
Table of Contents
