Avery Dennison Monarch Sierra Sport4 9493 Quick Reference page 3

C o n n e c t i n g t h e C o m m u n i c a t i o n s C a b l e
1.
Open the cable door on the side of the
printer by loosening the two screws with
a Phillips screwdriver.
2.
Plug the DB9 connector into the DB9
serial port.
3.
Place the cable in one of the cable
cavities.
4.
Close the cable door and tighten the
screws.
A USB cable is also available. Refer to the
Operator's Handbook for more information.
O p e n i n g a n d C l o s i n g t h e P r i n t e r
Before loading ribbon or supplies, you must open the printer.
Close the printer before printing.
To open the printer:
1.
Insert your fingers into the
indent beneath the supply door
latch and lift.
2.
Make sure the latch arms are
free of the ribbon cassette.
3.
Tip the ribbon cassette back, if
necessary, to lower the supply
door.
To close the printer:
1.
Tilt the ribbon cassette back if
necessary and raise the supply
door. Tilt the ribbon cassette
back down.
2.
Lift the supply door latch. Make
sure the latch arms catch each
side of the ribbon cassette.
3.
Push the supply door latch down
into place.
Latch Arms
3