Ricoh Aficio 1224C Settings Manual page 42

Basics
C C C C
Press [Interface Settings].
D D D D
Make [Effective Protocol] settings.
Note
❒ You must configure the IP Address for using TCP/IP protocol. Consult the
network administrator for help with the Address. You don't have to con-
figure it if Network Boot is DHCP.
2
❒ Press [Invalid] for redundant protocols.
❒ Press [Effective] for TCP/IP protocol when you use pure IP of NetWare
5/5.1.
A Press [Effective Protocol].
B Press [Invalid] or [Effective] for each protocol.
C Press [OK].
The following operation will be different, according to each protocol.
When using TCP/IP
A Make sure that [Network] is pressed, and then press [IP Address].
B Use the number keys to enter the IP address.
C Press [OK].
D Make the [Sub-net Mask] and [Gateway Address] settings. For each item,
press the corresponding button on the screen shown in step A A A A , and then
perform the same procedure as described in steps B B B B and C C C C .
26