Table of Contents
Advertisement
Install USB Drivers
This section contains instructions for installing the wireless home gateway USB
drivers if your PC is equipped with a USB interface and a Microsoft Windows 2000
or Windows XP operating system. The USB driver installation procedures are
different for each operating system. Follow the appropriate instructions in this
section for your operating system.
Note: If your PC does not have a USB interface, you may skip this section.
Installing USB Drivers on Windows 2000 Systems
1
Insert the USB Cable Modem Driver Installation Disk into the CD-ROM drive
of your PC.
2
Wait until the POWER and ONLINE LED status indicators on the front panel of
the wireless home gateway illuminate solid green.
Click Next in the Found New Hardware Wizard window.
3
4
Select Search for a suitable driver for my device (recommended) in the Found
New Hardware Wizard window, and then click Next.
5
Select CD-ROM drives in the Found New Hardware Wizard window, and then
click Next.
6
Click Next in the Found New Hardware Wizard window. The system searches
for the driver file for your hardware device.
7
After the system finds the USB driver, the Digital Signature Not Found window
opens and displays a confirmation message to continue the installation.
8
Click Yes to continue the installation. The Found New Hardware Wizard
window reopens with a message that the installation is complete.
9
Click Finish to close the Found New Hardware Wizard window. The USB
drivers are installed on your PC, and your USB devices are ready for use.
10 Try to access the Internet. If you cannot access the Internet, go to Having
Difficulty? (on page 52). If you still cannot access the Internet, contact your
service provider for further assistance.
Installing USB Drivers on Windows XP Systems
1
Insert the USB Cable Modem Driver Installation Disk into the CD-ROM drive
of your PC.
2
Wait until the POWER and ONLINE LED status indicators on the front panel of
the wireless home gateway illuminate solid green.
3
Select Install from a list or specific location (Advanced) in the Found New
Hardware Wizard window, and then click Next.
4
Select Search removable media (floppy, CD-ROM) in the Found New
Hardware Wizard window, and then click Next.
78-4011351-01 Rev B
Install USB Drivers
25
Advertisement
Table of Contents
Troubleshooting
