Cisco DPC2434 Installation And Operation Manual page 39

2 Power off your PC and unplug it from the power source.
3 Connect your PC to either the Ethernet port or the USB port using the appropriate
data cable.
Note: You can connect two separate PCs to the wireless home gateway at the
same time by connecting one to the Ethernet port and one to the USB port.
4 Insert the AC power cord into the power connector on the back of the wireless
home gateway, and then plug the other end into an AC power source.
Plug in and power on your PC.
5
Connect telephone port TEL1 (or Line 1 depending on your model) to your home
6
telephone jack. If your home is wired for a second telephone circuit, the connect
TEL2 (or Line 2 depending on your model) to the second telephone circuit.
Connect the active RF coaxial cable to the CABLE connector.
7
Note: Use an optional cable signal splitter to add a TV, a DHCT or set-top
converter, or a VCR.
8 The wireless home gateway will then begin an automatic search to locate and
sign on to the broadband data network.
Note: This process may take up to 5 minutes. The modem will be ready for use
when the ONLINE LED status indicator on the front panel stops blinking and
illuminates continuously.
9 Choose one of the following options:

To configure the TCP/IP protocol for Ethernet, go to Configure TCP/IP (on
page 22).
 To install the USB Drivers for USB, go to Install USB Drivers (on page 25).
78-4011351-01 Rev B
WARNING:
Avoid electric shock! Failure to unplug your PC from the power source may
create a shock hazard.
WARNING:
To avoid electric shock, disconnect your telephone company service at the
network interface device (demarcation point) before connecting the cable
modem telephone ports to your home telephone jacks.
Install the Wireless Home Gateway
21