Back Panel Description - Cisco DPC2434 Installation And Operation Manual

Chapter 1 Introducing the Model DPC2434 and EPC2434 VoIP Wireless Home Gateways

Back Panel Description

The following illustrations show the description and function of the back panel
components on the DPC2434 and EPC2434.
Internal Power Supply Model
DPC2434 (with internal power supply)
Important! Do not connect your PC to both the Ethernet and USB ports at the same
time. Your Internet service may not function properly if both the Ethernet and USB
ports are connected to the same PC at the same time.
1 POWER—Connects the wireless home gateway to the AC power cord
that is provided with your wireless home gateway
CABLE—F-connector connects to an active cable signal from your service
2
provider
RESET—Activating this switch resets the EMTA. Pressing this switch for
3
more than 10 seconds resets the device to factory default values and
resets the EMTA
6
CAUTION:
Avoid damage to your equipment. Only use the AC power cord
that is provided with your wireless home gateway.
CAUTION:
The Reset button is for maintenance purposes only. Do not use
unless instructed to do so by your cable or telephone service
provider. Doing so may cause you to lose any cable modem
settings you have selected.
78-4011351-01 Rev B