Cisco DPC2434 Installation And Operation Manual page 58

Chapter 4 Troubleshooting the Installation
Normal Operations (AC Power Applied)
The following chart illustrates the appearance of the LED status indicators on the
front panel of the wireless home gateway during normal operations when AC power
is applied to the wireless home gateway.
Step
Front Panel LED Status Indicators During Normal Operations
Front Panel
Indicator
1 POWER
2 DS
3 US
4 ONLINE
5 LAN 1
through
LAN 4/USB
6 WIRELESS
7 TEL1
8 TEL2
9 BATTERY
40
Normal Operations
Normal Operations
ON
ON
ON
ON
ON - When a single device is connected to either the Ethernet or USB
port and no data is being sent to or from the modem
BLINKS - When only one Ethernet or USB device is connected and
data is being transferred between the consumer premise equipment
(CPE) and the wireless home gateway
OFF - When no devices are connected to either the Ethernet or USB
ports
Note: With both Ethernet and USB devices connected to the modem at
the same time, when data is being transferred through only one of the
devices (Ethernet or USB), the indicator will illuminate continuously.
Whenever data is being sent through both data ports (Ethernet and
USB) simultaneously, the indicator will blink as described above.
ON when the wireless access point is enabled and operational

BLINKS when data is being transferred between the CPE and the

wireless home gateway
OFF when the wireless access point is disabled by the user

ON when telephony service is enabled

BLINKS when line 1 is in use

ON when telephony service is enabled

BLINKS when line 2 is in use

ON when battery is charged

BLINKS when battery charge is low

OFF when there is no battery in the unit

78-4011351-01 Rev B