Table of Contents
Advertisement
3
Connect the active RF coaxial cable to the CABLE connector on the back of the
wireless home gateway. The wireless home gateway begins an automatic search
to locate and sign on to the network that provides the telephone service. This
process may take up to 5 minutes. The modem will be ready for use when the
ONLINE LED status indicator on the front panel stops blinking and illuminates
continuously
Note: Use an optional cable signal splitter to add a TV, a DHCT or set-top
converter, or a VCR.
4
Test your telephone service by lifting the receiver of each attached telephone to
verify that the dial tone can be heard and that you can make and receive
telephone calls. This process may take several minutes.
Notes:
The TEL 1 and TEL 2 LED status indicators on the front panel of the wireless
home gateway illuminate when telephony service is enabled.
The TEL 1 or the TEL 2 LED status indicators on the front panel of the
wireless home gateway blink when the attached device is "off the hook."
78-4011351-01 Rev B
Install the Cable Modem to Provide Telephone Service
35
Advertisement
Table of Contents
Troubleshooting
