About The Battery - Cisco DPC2434 Installation And Operation Manual

Voip wireless home gateways
Hide thumbs Also See for DPC2434:
Table of Contents

Advertisement

About the Battery

Your modem includes up to two rechargeable Lithium-Ion batteries to provide
stand-by operation in the event of an AC power failure. You can replace one or both
of the batteries without the use of any tools.
WARNING:
There is danger of explosion if the battery is mishandled or incorrectly
replaced. Replace only with the same type of battery. Do not disassemble it or
attempt to recharge the battery outside the system. Do not crush, puncture,
dispose of in a fire, short external contacts, or expose to water or other liquids.
Dispose of the battery in accordance with local regulations and instructions
from your service provider.
Charging the Batteries
The batteries begin to charge automatically as soon as you attach the modem to the
AC electrical outlet. When you first plug in the modem, the POWER LED status
indicator illuminates.
Important! It may take as long as 24 hours for each battery to charge fully.
Using the Modem Without a Battery
If you want, you can use the modem without a battery. If you need to remove the
batteries, follow the procedures found in Removing and Replacing the Batteries (on
page 30).
Important! If you choose to operate your modem without a battery, you risk losing
your telephone service during a power outage.
Replacing the Batteries
Under normal circumstances, the battery should last for several years. The
BATTERY LED status indicator turns off to indicate that the battery should be
replaced soon. Contact your service provider to obtain replacement batteries and for
disposal instructions.
Note: Follow the steps found in Removing and Replacing the Batteries (on page 30),
to remove and replace one or both of the batteries.
78-4011351-01 Rev B

About the Battery

29

Advertisement

Table of Contents
loading

This manual is also suitable for:

Epc2434

Table of Contents