Installing The Canopy And Canopy Trim Ring - Hunter 42743-01 Installation And Operation Manual

5 • Installing the Canopy and Canopy Trim Ring
Step 5-2
Canopy

Steps 5-4 – 5-5
Hunter Fan Company
5-1. Holding the canopy, raise the fan off the hook.
Ceiling Plate
5-2. Align the slots in the canopy with the tabs on the ceiling plate.
5-3. Raise the canopy over the ceiling plate. Rotate the canopy
clockwise until the tabs on the ceiling plate totally engage with
the slots in the canopy.
5-4. Loosely assemble the three canopy screws into the canopy one at
Canopy Trim
Ring
a time. Once all three screws are in, tighten them.
5-5. Using both hands, push the canopy trim ring up to the top of the
canopy. The canopy trim ring will snap and lock into place.
Step 5-3
Canopy
Should you need to remove the canopy
trim ring, follow these steps:
1. L ocate the tab indicators, small
bumps on top of tabs.
2. P ress firmly on opposite sides of the
ring towards the canopy. The tabs
will flex out releasing the trim ring
from the canopy
Screw
42743-01 • 04/15/07