Table of Contents
Related Manuals for Episode E-2100
Summary of Contents for Episode E-2100
- Page 1 OWNER’S MANUAL >>AMPLIFIER E-2100 - STEREO POWER AMPLIFIER IMPORTANT SAFETY INSTRUCTIONS INTRODUCTION & FEATURES INSTALLATION A. FIRST STEPS B. GETTING CONTROL C. GETTING CONNECTED SETTING UP AMPLIFIER TROUBLESHOOTING SPECIFICATIONS...
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus in or near rain or moisture 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. -
Page 3: 2-Channel Amplifier Features
>>POWER MODE There are three choices for power modes with an Episode amplifier; ‘On’, ‘Auto’ and ‘Trigger’. When the ‘On’ mode is enabled, your amplifier will remain on as long as it is plugged in to power and the main power switch on the front panel is switched to the on position. - Page 4 Analog Inputs: When using as a subwoofer amp, use the supplied Y adapter cable as instructed. Volume Control Low pass enable Pass-through outputs allow inputs to be sent to other amplifiers Low pass frequency adjustments...
- Page 5 5-way binding post speaker outputs Bridging switch. Easily couple two channels together for Fuse holder. increased power. Power-on mode controls. Choose among three different methods to turn on the amplifier. Use the low voltage input and output when using the ‘trigger’ mode. Power connector.
-
Page 6: Placing
• Listen to the bass. Is it full or thin? Listen to volume of the bass as well. • Turn off your receiver and reverse the connections for one of the speakers connected to your Episode amplifier. • Repeat your test at the same volume level. When the sound has the loudest and best sounding bass and also sounds best in the vocal region, your connections are correct and in-phase. -
Page 7: Setup And Options
The bridged output is 8 OHM. Do not connect speakers impedances lower than 8 OHM to the E-2100 in bridged mode. Note: CH1 (+) Red and (–) ( + ) CH2 (-) Black are your bridged speaker connections. -
Page 8: Typical Installation
EPISODE TYPICAL INSTALLATION - WITH SPEAKERS ® STEREO SOURCE Set to FLAT Set to STEREO... - Page 9 EPISODE TYPICAL INSTALLATION - WITH SPEAKER SELECTOR BOX ® STEREO SOURCE Set to FLAT ESS-6 Amp Protection Set to STEREO Amp i ier one 6 one 5 one 4 one 3 one 2 one 1...
-
Page 10: Subwoofer Out
EPISODE BRIDGED SUBWOOFER APPLICATION ® SUBWOOFER OUT Set to LOW PASS Y-ADAPTER Set to BRIDGED PASSIVE SUBWOOFER... -
Page 11: Troubleshooting
The amplifier is designed to function trouble-free. Most problems that occur are due to simple issues. If you have trouble, please check the list of simple fixes below. If the problem persists, contact your authorized Episode dealer or Episode customer service at 866.838.5052 •Power cable to the amplifier is incorrectly connected or plugged into an outlet... -
Page 12: Specifications
SnapAV or a designated service center with prior notification and an assignment return authorization number (RA). Meets FCC Part 15 and ICES-003, Class B for USA and Canada ETL Listed Certification and tested under UL/EN60065 Episode Speakers 10405-A Granite Street Charlotte, NC 28273 704.927.7607 www.episodespeakers.com...