Advertisement
Step 6: Final Wiring
A.
Connect electrical supply leads to the leads from motor,
using approved connectors. Connect black electrical supply lead
to the black motor lead and the black with white stripe motor
lead (see Note). Connect the white electrical supply lead to the
white motor lead. Connect the ground wire to the green leads
from the motor and ceiling plate. See Figure 6.
GREEN GROUND WIRE
FIGURE 6
NOTE: If a separate wall switch will be used to control a light-
ing accessory, connect the black wire with white stripe to the
wall switch lead. The wall switch must be acceptable for use as
a general-use switch.
CAUTION: No bare wire or wire strands should be visible
after making connections.
B.
After making the wire connections, the wires should be
spread apart with the white and green wires on one side of the
outlet box, and the black and black/white wires on the other side
of the box.
The splices should be turned upward and pushed carefully up
into the outlet box.
Step 7: Finish Fan Assembly
A.
The ceiling plate has (3) mounting screw holes located on
the side. Install (2) #10-32 x
halfway into two of these holes. See Figure 7.
Remove the fan from the ceiling plate hook. Make sure not to
break any wire connections. The canopy has (2) mating slots
and (1) mating hole. See Figure 7.
FIGURA 7
40955-01 1/91
CEILING PLATE
1
⁄
" Phillips round head screws
2
CEILING PLATE
MOUNTING SCREWS
MOUNTING HOLE
CANOPY
MOUNTING SLOTS (2)
LEAD WIRES
CANOPY
GROOVE IN BALL
PIPE NIPPLE
B.
Position (2) slots in canopy directly under and in line with
(2) mounting screws in ceiling plate. Lift fan until ceiling plate
mounting screws are seated in bottom of slots in canopy. Rotate
fan counterclockwise until both mounting screws drop into slot
recesses. Tighten screws securely. Install third screw into
mounting hole.
CAUTION: Failure to securely assembly the canopy screws
could result in the fan falling.
NOTE: For the handing fan configuration, rotate fan until
groove in ball is positioned over tab in canopy. Make certain
groove and tab are engaged before running fan. See Figure 7A.
Failure to do this could result in the fan falling.
Step 8: Fan Blade Assembly,
Installation, and Balancing
A.
Attach wood blades to blade brackets using three screws for
each blade. See Figure 8. If your blades have large holes you must
first insert the rubber grommets into the holes. See Figure 8A.
NOTE: Grommets are usually assembled by hand. If you use a
tool, make certain you do not damage the grommet or blade
when inserting the grommets.
Next assemble the blade to the blade bracket. Make sure all
screws are tight to prevent vibration or wobbling. A cavity in
the styrofoam packaging has been provided to nest the parts in
during assembly to assure correct alignment of parts.
Even when the screws are tight, the blades may seem to be
loose. This is normal when using grommets and will not be
a problem.
FIGURE 8
-3-
ROTATE BALL UNTIL GROOVE IN BALL
ENGAGES TAB IN CANOPY
FIGURA 7A
GROMMET
FIGURE 8A
©1991 HUNTER FAN CO.™
BLADE
Advertisement
