Porter-Cable CPLC7060V Instruction Manual page 14

7. Check all air line fittings and con-
nections/piping for air leaks by
applying a soap solution. Correct
if necessary. NOTE: Minor leaks
can cause the air compressor to
overwork, resulting in premature
breakdown or inadequate perfor-
mance.
8. Check for excessive vibration.
Readjust or shim air compressor
feet, if necessary.
9. After 20 minutes, close the globe
valve. The air receiver will fill to
"cut-out" pressure and the motor
will stop.
The compressor is now ready for use.
Before Each Start-Up
1. Place On/Auto/Off lever to "Off".
2. Close the globe valve.
3. Visually inspect air hose, replace if
needed.
4. Attach hose and accessories.
Risk of unsafe opera-
tion. Firmly grasp air hose in hand
when installing or disconnecting to
prevent hose whip.
Risk of unsafe opera-
tion. Do not use damaged or worn
accessories.
NOTE: A regulator MUST be installed
when using accessories rated at less
than 110 psi.
NOTE: The hose or accessory will
require a quick connect plug if the air
outlet is equipped with a quick connect
socket.
N003195
Risk of bursting. Too
much air pressure causes a haz-
ardous risk of bursting. Check the
manufacturer's maximum pressure
rating for air tools and accessories.
The regulator outlet pressure must
never exceed the maximum pressure
rating.
Risk of unsafe opera-
tion. Compressed air from the unit
may contain wa ter condensation and
oil mist. Do not spray un fil tered air
at an item that could be damaged by
moisture. Some air tools and acces-
sories may require filtered air. Read
the in struc tions for the air tools and
accessories.
How to Start
1. Turn the On/Auto/Off lever to "On/
Auto" and allow tank pressure to
build. Motor will stop when tank
pressure reaches "cut-out" pres-
sure.
2. When the tank pressure reaches
"cut-out" pressure open the globe
valve.
IMPORTANT: When using regulator and
other accessories refer to the manufac-
turers instructions.
Risk of bursting. If any
unusual noise or vibration is noticed,
stop the compressor immediately
and have it checked by a trained
service technician.
The compressor is ready for use.
14 - ENG