Service The Parksense® Rear Park Assist; System - Jeep 2014 Grand Cherokee Owner's Manual

220 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Enabling And Disabling ParkSense®
ParkSense® can be enabled and disabled with the
ParkSense® switch.
When the ParkSense® switch is pressed to dis-
able the system, the instrument cluster will dis-
play the "PARKSENSE OFF" message for ap-
proximately five seconds. Refer to "Electronic
Vehicle Information Center (EVIC)" in "Understanding
Your Instrument Panel" for further information. When the
shift lever is moved to REVERSE and the system is
disabled, the EVIC will display the "PARKSENSE OFF"
message for as long as the vehicle is in REVERSE.
The ParkSense® switch LED will be ON when ParkSense®
is disabled or requires service. The ParkSense® switch LED
will be OFF when the system is enabled. If the ParkSense®
switch is pressed, and the system requires service, the
ParkSense® switch LED will blink for approximately 3 sec-
onds, and then the LED will be ON.
Service The ParkSense® Rear Park Assist

System

When the ParkSense® Rear Park Assist System is mal-
functioning, the instrument cluster will actuate a single
chime, once per ignition cycle, and it will display the
"CLEAN PARK ASSIST SENSORS" or the "SERVICE
PARK ASSIST SYSTEM" message. Refer to "Electronic
Vehicle Information Center (EVIC)" in "Understanding
Your Instrument Panel" for further information. When
the shift lever is moved to REVERSE and the system has
detected a faulted condition, the EVIC will display the
"PARK ASSIST SYSTEM OFF" message for as long as the
vehicle is in REVERSE. Under this condition, ParkSense
will not operate.