Parksense® Sensors; Parksense® Warning Display - Jeep 2014 Grand Cherokee Owner's Manual

ParkSense® will retain the last system state (enabled or
disabled) from the last ignition cycle when the ignition is
changed to the ON/RUN position.
ParkSense® can be active only when the shift lever is in
REVERSE. If ParkSense® is enabled at this shift lever
position, the system will remain active until the vehicle
speed is increased to approximately 7 mph (11 km/h) or
above. The system will become active again if the vehicle
speed is decreased to speeds less than approximately
6 mph (9 km/h).
ParkSense® Sensors
The four ParkSense® sensors, located in the rear fascia/
bumper, monitor the area behind the vehicle that is
within the sensors' field of view. The sensors can detect
obstacles from approximately 12 in (30 cm) up to 79 in
(200 cm) from the rear fascia/bumper in the horizontal
direction, depending on the location, type and orienta-
tion of the obstacle.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 215
ParkSense® Warning Display
The ParkSense® Warning screen will only be displayed if
Sound and Display is selected from the Customer - Pro-
grammable Features section of the Electronic Vehicle Infor-
mation Center (EVIC) or from the Uconnect® System (if
available). Refer to "Electronic Vehicle Information Center
(EVIC)/Personal Settings (Customer-Programmable Fea-
tures)" or Uconnect® Settings" (if available) in "Under-
standing Your Instrument Panel" for further information.
The ParkSense® Warning screen is located within the
Electronic Vehicle Information Center (EVIC). It provides
visual warnings to indicate the distance between the rear
fascia/bumper and the detected obstacle. Refer to "Elec-
tronic Vehicle Information Center (EVIC)/Settings" in
Understanding Your Instrument Panel" for further infor-
mation.
3