Table of Contents
Advertisement
Adjustable Chime Volume Settings
Rear chime volume settings can be selected
from the Customer-Programmable Features
section of the Uconnect System, refer to
"Uconnect Settings" in "Multimedia" for further
information.
The chime volume settings include low,
medium, and high. The factory default volume
setting is medium.
ParkSense will retain its last known
configuration state through ignition cycles.
ParkSense Warning Display
The ParkSense Warning screen will only be
displayed if Sound and Display is selected from
the Customer - Programmable Features section
of the Uconnect System.
Refer to "Uconnect Settings" in "Multimedia" for
further information.
The ParkSense Warning screen is located within
the instrument cluster display. It provides visual
warnings to indicate the distance between the
rear fascia/bumper and the detected obstacle.
Refer to "Instrument Cluster Display" in
"Getting To Know Your Instrument Panel" for
further information.
Enabling And Disabling ParkSense
ParkSense can be enabled and disabled with
the ParkSense switch.
When the ParkSense switch is pushed
to disable the system, the instrument
cluster will display the "PARKSENSE
OFF" message for approximately five
seconds. When the gear selector is moved to
REVERSE and the system is disabled, the
instrument cluster display will display the
"PARKSENSE OFF" message for as long as the
vehicle is in REVERSE.
Refer to "Instrument Cluster Display" in
"Getting To Know Your Instrument Panel" for
further information.
The ParkSense switch LED will be on when
ParkSense is disabled or requires service. The
ParkSense switch LED will be off when the
system is enabled. If the ParkSense switch is
pushed, and the system requires service, the
ParkSense switch LED will blink momentarily,
and then the LED will be on.
STARTING AND OPERATING
Service The ParkSense Rear Park Assist
System
During vehicle start up, when the ParkSense
Rear Park Assist system has detected a faulted
condition, the instrument cluster will actuate a
single chime, once per ignition cycle, and it will
display the "PARKSENSE UNAVAILABLE WIPE
REAR SENSORS" or the "PARKSENSE
UNAVAILABLE SERVICE REQUIRED" message.
Refer to "Instrument Cluster Display" in
"Getting To Know Your Instrument Panel" for
further information. When the gear selector is
moved to REVERSE and the system has
detected a faulted condition, the instrument
cluster display will display the "PARKSENSE
UNAVAILABLE WIPE REAR SENSORS" or
"PARKSENSE UNAVAILABLE SERVICE
REQUIRED" message for as long as the vehicle
is in REVERSE. Under this condition, ParkSense
will not operate.
231
5
Hide quick links:
Advertisement
Table of Contents
