To Deactivate; To Resume Speed; To Vary The Speed Setting - Jeep 2014 Grand Cherokee Owner's Manual

184 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

To Deactivate

A soft tap on the brake pedal, pushing the CANCEL
button, or normal brake pressure while slowing the
vehicle will deactivate Electronic Speed Control without
erasing the set speed memory. Pressing the ON/OFF
button or turning the ignition switch OFF erases the set
speed memory.

To Resume Speed

To resume a previously set speed, push the RES button
and release. Resume can be used at any speed above
20 mph (32 km/h).

To Vary The Speed Setting

When the Normal (Fixed Speed) Cruise Control is set,
you can increase speed by pushing the SET (+) button. If
the button is continually pressed, the set speed will
continue to increase until the button is released, then the
new set speed will be established.
Pressing the SET (+) button once will result in a 1 mph
(1 km/h) increase in set speed. Each subsequent tap of
the button results in an increase of 1 mph (1 km/h).
While the Normal (Fixed Speed) Cruise Control is set,
you can increase the set speed by pressing and holding
the SET + button. If the button is continually pressed, the
set speed will continue to increase in 5 mph (10 km/h)
increments until the button is released. The increase in set
speed is reflected in the EVIC display.
To decrease speed while the Normal (Fixed Speed) Cruise
Control is set, push the SET (-) button. If the button is
continually held in the SET (-) position, the set speed will
continue to decrease until the button is released. Release
the button when the desired speed is reached, and the
new set speed will be established.
Pressing the SET (-) button once will result in a 1 mph
(1 km/h) decrease in set speed. Each subsequent tap of
the button results in a decrease of 1 mph (1 km/h).