Ignition System Wiring - Heat & Glo ST-HVBI-AUB Owner's Manual

1.5 IGNITION SYSTEM WIRING

• This gas heater is equipped with an electronic ignition
system which operates on a 6 volt system.
• This appliance requires 220-240 VAC to be wired
to the factory installed junction box. Check factory
installed power cord for damage before using.
WARNING
Shock hazard.
• Replace damaged wire with type 105º C
rated wire.
• Wire must have high temperature
insulation.
CAUTION
Label all wires prior to disconnection when servicing con-
trols. Wiring errors can cause improper and dangerous
operation. Verify proper operation after servicing.
GROUND
TO CHASSIS
TO AUX300CE
6V DC SUPPLY
DC REGULATOR
ORANGE
Figure 32
IGNITOR
FLAME
SENSE
CONTROL MODULE
8K1 WIRE
HARNESS
RED
GREEN
(PILOT) (MAIN) BLACK
BROWN
Heat & Glo • ST-HVBI-AUB • 2082-980 Rev. B • 3/11
240V FAN
I
AUX300CE MODULE
S
AUX 1
BATTERY PACK
6V DC (C X 4)
GROUND
FAN
AUX 2
TO OPTIONAL
COMPONENTS
OPTIONAL ON/OFF
WALL SWITCH
TO JUNCTION
BOX 230 VAC
22