Fujitsu s3-0801 User Manual page 26

3. Local Port Operation
The order in which the servers appear in the Scan dialog box is based on the order in
which they were selected. Scanning a single server multiple times during a loop is not
supported. Scan time must be the same for all servers.
Enabling or disabling Scan mode
To start the Scan mode:
1. Activate the OSD and click Commands. The Commands dialog box displays.
2. Select Scan Enable in the Commands dialog box. Scanning will begin.
3. Click X to close the Commands dialog box.
To cancel Scan mode:
Select a target device if the OSD is open.
-or-
Move the mouse or press any key on the keyboard if the OSD is not open.
Scanning will stop at the currently selected target device.
-or-
From the Commands dialog box, deselect the Scan Enable checkbox.
Viewing and disconnecting user connections
You can view and disconnect users through the User Status dialog box. The
username (U) and server (S) will always be displayed when connected to a target
device. You can display either the target device name or EID number to which a
user is connected. If there is no user currently connected to a channel, the
username and server fields will be blank.
To view current user connections, activate the OSD and click Commands - User
Status to open the User Status dialog box.
To disconnect a user:
1. On the User Status dialog box, click the letter corresponding to the user to
open the Disconnect dialog box.
2. Click Disconnect to disconnect the user and return to the User Status dialog
box.
-or-
Click X or press Escape to exit the dialog box without disconnecting a user.
20
590-1035-640A