Fujitsu s3-0801 User Manual page 25

Features
IQ Status
Display
Versions
Display Config
Device Reset
To access the OSD interface Commands dialog box:
Activate the OSD interface and click Commands to open the dialog box.
Selecting target devices for Scan mode
The Scan dialog box allows the local user to define a custom list of servers to
include while in Scan mode and the number of seconds to display each server.
The creation of the Scan list does not start Scan mode. You must enable Scan
mode via the Scan Enable checkbox on the Commands dialog box. The Scan list
is displayed in the manner set from the Menu dialog box. It can be changed in the
Scan dialog box to sort either by Name, EID or Port by choosing one of the
buttons. If a server on the list is unavailable, it is skipped. Watch mode views a
server unless a conflicting network user blocks the path to that server. If a conflict
is detected in Watch mode (or the server is unavailable), the server to be viewed
is skipped.
To add target devices to the Scan list:
1. Activate the OSD and click Setup - Scan to open the Scan dialog box.
2. The dialog box contains a listing of all servers attached to your switch. Click
the checkbox to the right of the server, double-click on the desired entry, or
highlight the device and click the Add/Remove button to toggle the scan
checkbox setting. You can select up to 100 servers for inclusion in the Scan
list.
Click the Clear button to remove all servers from the Scan list.
3. In the Time field, type the number of seconds (from 3 - 255) to display each
server while scanning. The default is 15 seconds per server.
4. Click OK.
590-1035-640A
Purpose
Displays the currently available firmware for each type of IQ
module.
View version information for the switch as well as view and
upgrade firmware for individual IQ modules.
View current configuration parameters.
Re-establish operation of PS/2 keyboard and mouse on the
local port.
3.3 Commands Dialog Box Functions
19