Remote Jack - Sanyo SRT-7168P Instruction Manual

OUTPUT TERMINALS

REMOTE Jack

You can use a VA-RMN01 Remote Control Unit (sold
separately) to control remotely the VCR.
NOTE:
œ The functions not available on the VCR will not
operate.
Remote control of the VCR is possible by connecting a
remote controller with a circuit such as indicated below,
to the REMOTE jack.
NOTES:
œ Use a 3.5 mm mini-jack type plug.
œ The connection should be done using a shielded
cable no more than 5 meters long.
œ The functions not available on the VCR will not
operate.
Remote control circuit
R0 1.2K
R1 0.3K
R2 0.43K
R3 0.51K
R4 0.62K
R5 0.75K
R6 0.91K
R7 1.1K
R8 1.3K
R9 2.0K
R10 2.4K
R11 3.6K
R12 5.6K
The resistance tolerance is
2% or less.
SW0: EJECT
SW1: STOP
SW2: STILL/PAUSE
SW3: REW
SW4: FF
SW5: PLAY
SW6: REC
SW7: EJECT (or MENU)
SW8: REV
SW9: REC/PLAY SPEED j, j
SW10: REC/PLAY SPEED l, l
SW11: SHIFT ], »
SW12: SHIFT «, «
Remote control setting
The remote control switch 7 can be set to either eject
the tape or access the menus.
1
Press the MENU button until the (SET UP 1) menu
is displayed.
@@@@@@@<SET@UP@1>
öSUMMER@TIME@SET@@USE
@@@@@@@@WEEK@MONTH@TIME
@ON@@@LST-SUN@@03@02:00
@OFF@@LST-SUN@@10@02:00
öOUTPUT@@@@@@@@SERIES
öCLOCK@SET
@15-10-99@FRI@@15:20:00
öREMOTE@@@@@@@@EJECT
öLANGUAGE-LANGUE-SPRACHE
@@@ENGLISH
2
Turn the JOG dial, until the "REMOTE" setting is
flashing.
3
Turn the SHUTTLE ring, to select the desired switch
mode.
EJECT . . . . . Switch 7 will eject the tape.
MENU . . . . . Switch 7 will display the menu.
4
Press the SEARCH button to save the setting.
36
English