Sanyo SRT-7168P Instruction Manual page 16

NORMAL RECORDING
Concerning the Number of Times Tapes
can be Rerecorded on
Depending on the recording speed mode, the tape must
be replaced after a certain number of recording times.
Refer to the table below for the maximum number of
times a tape can be recorded on.
Recording speed mode
(hour mode)
6, 8
18, 24
30, 40
48, 64
72, 96
96, 128
120, 160
168, 224
NOTES:
œ The maximum number of recording times will vary
depending on the location and kind of tape used.
Verify the recording quality and replace the tape
when the quality starts to deteriorate.
The maximum number of recording times indicated
above are based on test tapes (E-180 and E-240)
used by the company.
œ If using longer tapes (i.e. E-300) the tape travel will
not be as stable and that may cause problems.
English
Maximum number of
recording times
(with a standard grade
tape)
100
50
50
25
10
6
5
3
Changes to the Recording Speed Mode
During Recording
It is possible to permit or prevent changing the
recording speed mode during recording.
1
Press the MENU button until the (SET UP 4) menu
is displayed.
@@@@@@@<SET@UP@4>
öSW@OUT
@@FIELD@@@@@@@@@01
@@TIMING@@@@@@@@FIELD
@@8H@@@@@@@@@@@@Y
öTHREAD@CHECK@@@Y
öVIDEO@LOSS@@@@@N
öREC@SPEED@@@@@@N
öVERTICAL@SYNC@@Y
2
Turn the JOG dial, until the "REC SPEED" setting is
flashing.
3
Turn the SHUTTLE ring, to set the desired mode.
Y. . . . . . . . . . Recording speed mode can be
N. . . . . . . . . . Recording speed mode can not
4
Press the SEARCH button to save the setting.
Action to Take when the Video Signal
Deteriorates
If there is no video signal during recording, fast forward,
rewind modes, when in stop mode or when a tape is not
loaded the menus are not displayed, "VIDEO LOSS"
can be displayed on-screen and a signal (0 V) can be
output at the ALARM OUT terminal. If in the (SET UP
2) menu, in the BUZZER section WARNING is set to
"Y", the buzzer will be heard. To stop the buzzer, press
the STOP button.
1
Press the MENU button until the (SET UP 4) menu
is displayed.
2
Turn the JOG dial, until the "VIDEO LOSS" setting
is flashing.
3
Turn the SHUTTLE ring, to set the desired mode.
N. . . . . . . . . . The video loss warning is not
Y. . . . . . . . . . The video loss warning is active.
4
Press the SEARCH button to save the setting.
15
changed
be changed
active.