Phases Of The Diagnostic Cycle - Electrolux EWM1000 Service Manual

ENV06 EWM11xx EWM21xx EWM25xx/35xx

3.3 Phases of the diagnostic cycle

Irrespective of the type of PCB and the configuration of the programme selector it is possible, after entering
diagnostic mode, turning the programme selector clockwise or pushing the buttons P1 or P2 (INPUT
version), to perform diagnostics on the operation of the various components and to read the alarms.
All the alarms are enabled during the diagnostic cycle.
Selector position
1
2
3
4
5
6
7
8
9
QUICK GUIDE AND APPLIANCES LIST
Components actioned
INPUT
- All the LEDs and symbols
light in sequence.
- When a button is pressed,
the corresponding LED or
symbol light.
INPUT
-
Door interlock
- Wash solenoid
INPUT
- Door interlock
- Pre-wash solenoid
INPUT
- Door interlock
- Pre-wash and wash
solenoids
INPUT
- Door interlock
- Bleach/stains solenoids
INPUT -
Door interlock
- Wash solenoid if the level
of water in the tub does
not cover the heater
- Heating element
- Recirculation pump
- Door interlock
INPUT - Wash solenoid if the level
of water in the tub does
not cover the heater
- Motor (55 rpm clockwise,
55 rpm counter-
clockwise, 250 rpm
impulse)
INPUT
- Door interlock
- Drain pump
- Motor up to 650 rpm then
at maximum spin speed
(**)
INPUT
- Door interlock
- Drain pump
- Motor fan
- Condensation solenoid
valve
- Drying heating element
Operating
conditions
Always activated
Door locked
Water level below
anti-flooding level
Maximum time 5
minutes
Door locked
Water level below
anti-flooding level
Maximum time 5
minutes
Door locked
Water level below
anti-flooding level
Maximum time 5
minutes
Door locked
Water level below
anti-flooding level
Maximum time 5
minutes
Door locked
Water level above
the heater
Maximum time 10
minutes or up to
90°C (*)
Door locked
Water level above
the heater
Door locked
Water level lower
than anti-boiling
level for spinning
Door locked
Water level lower
than anti-boiling
level
43/176
Function
LCD
checked
All symbols are
activated in
Operation of
sequence, the
the user
backlight lights
interface
up and then
switches off.
Water ducted
Displays the
through
water level in
washing
tub
compartment
Water ducted
through pre- Displays the
wash water level in
compartment tub
(bleach)
Water ducted
Displays the
through
water level in
conditioner
tub
compartment
Water ducted
through Displays the
conditioner/stai water level in
ns tub
compartments
Heating Wash water
Recirculation temperature
Displays the
Check for leaks drum speed
from the tub
(the real value
divided by ten)
Drain and spin;
control of
Displays the
congruence in drum speed
closure of level (the real value
pressure
divided by ten)
switches
Displays the
Drying
air temperature
599 72 40-80