Lcd Version With Selector And Button On/Off Switch; Access To Diagnostics System; Rapid Reading Of Alarm Codes; Cancelling The Last Alarm - Electrolux EWM1000 Service Manual

EWM1000plus EWM2000evo EWM3000new

2.8 LCD Version with selector and button ON/OFF switch

2.8.1

Access to diagnostics system

1. Cancel the set programme and switch the appliance off.
2. Press the start/pause and exit buttons simultaneously, then, holding them down, switch the
appliance on rotating the programme selector of one position clockwise.
3. Hold the START/PAUSE and EXIT buttons down up to DIAGNOSTIC MODE appears (about 5
seconds).
4. To exit the diagnostic system switch the appliance off, on and then off again.
2.8.2

Rapid reading of alarm codes

The last alarm code can be displayed even if the programme selector is not in the tenth position
(diagnostics) or if the appliance is in normal operating mode (e.g. during the execution of the washing
programme):
Five minutes after the switching on, press and hold down the START/PAUSE and EXIT buttons for 2
seconds, the LCD displaying shows the last alarm codes (of the main board and display board). The
displaying of the alarms depends on the time in which the buttons are hold down.
During the time the alarm is displayed, the appliance continues to perform the cycle or, if it is in the
selection phase, it keeps in memory the options previously chosen.
2.8.3

Cancelling the last alarm

It is good practice to cancel the last alarm, after reading the alarm code to check whether the alarm re-
occurs during the diagnostics control after the reparation of the appliance
1. Select diagnostics mode and turn the programme selector to the tenth position (reading of alarm)
2. Press simultaneously START/PAUSE button and button EXIT (nearest option to START/PAUSE
button).
3. Hold down the START/PAUSE and EXIT button until the alarms are cancelled.
QUICK GUIDE AND APPLIANCES LIST
23/176
599 72 40-80