Table of Contents
Advertisement
User select box
This selection box displays the user ID for which the values are shown and for which the
changes will take effect. You may change the settings of other users if you have the
required privileges.
Transmission Encoding
The Transmission Encoding setting allows changing the image-encoding algorithm that is
used to transmit the video data to the Remote Console window. It is possible to optimize
the speed of the remote screen processing depending on the number of users working at
the same time and the network bandwidth of the connection line (Modem, ISDN, DSL,
LAN, etc.).
Automatic detection
The encoding and the compression level is determined automatically from the
available bandwidth and the current content of the video image.
Pre-configured
The pre-configured settings deliver the best result because of optimized adjustment
of compression and colour depth for the indicated network speed.
Manually
Allows to adjust both compression rate and the colour depth individually. Depending
on the selected compression rate the data stream between the IP-KVM switch and
the Remote Console will be compressed in order to save bandwidth. Since high
compression rates consum more computing power of IP-KVM switch, they should not
be used while several users are accessing the IP-KVM switch simultaneously.
The standard color depth is 16 Bit (65536 colors). The other color depths are
intended for slower network connections in order to allow a faster transmission of
data. Therefore compression level 0 (no compression) uses only 16 Bit color depth.
At lower bandwidths only 4 Bit (16 colors) and 2 Bit (4 gray scales) are recommended
for typical desktop interfaces. Photo-like pictures have best results with 4 Bit (16 gray
Figure 6-20. User Console Settings (Part 1)
62 / 92
8/16-Port KVM over IP Switch
Advertisement
Table of Contents
