Table of Contents
Advertisement
Video Settings through the remote console
Brightness Controls the brightness of the picture
Contrast Controls the contrast of the picture
Clock Defines the horizontal frequency for a video line and depends on the video
mode. Different video card types may require different values here. The
default settings in conjuction with the auto adjustment procedure should be
adequate for all common configurations. If the picture quality is still bad after
auto adjustment you may try to change this setting together with the sampling
phase to achieve a better quality.
Phase Defines the phase for video sampling, used to control the display quality
together with the setting for sampling clock.
Horizontal Position Use the left and right buttons to move the picture in
horizontal direction while this option is selected.
Vertical Position Use the left and right buttons to move the picture in vertical
direction while this option is selected.
Reset this Mode Reset mode specific settings (Clock , Phase and Position) to
the factory-made defaults.
Reset all Modes Reset all settings to the factory-made defaults.
Save changes Save changes permanently
Undo Changes Restore last settings
• Refresh Video
Click to run this menu item for retrieving the whole video again from the controlled host
and displayed on Remote Console. In normal situation, only changed parts of video will
be packed and sent from IP-KVM switch, for saving network bandwidth. This function is
mainly used for troubleshooting purpose where some old video fragments are displayed
Figure 5-10. Video Settings Panel
41 / 92
8/16-Port KVM over IP Switch
Advertisement
Table of Contents
