P-Link Computer KVM-MU108AP User Manual page 33

To use "Tab" key to select items like Bank, OSD, SCAN, CHANGE PASSWORD,
a. The "OSD: 10 SEC" means that the OSD windows display or PC system name exists
10 sec. on your monitor. You can modify it from 05 sec to 99 sec. The factory default
value is 10 sec.
b. The "SCAN TIME" means that scan interval from one PC port to next PC port. The
default SCAN time is 10 sec and the maximum scan time is 99 sec.
c. The "CHANGE PASSWORD" is for user to avoid all PC systems to be intruded by the
other person. The default password is 8 digits "00000000".
There is an enter password window showed out when you select this item and then
press the Enter. The maximum password is 8 digits. After you key in the password
already and press the Enter key, there is another window for confirming your typed
password.
You need to retype the password again for rechecking your previous key-in password is
matched or not.
d. The " CONSOLE ON/OFF " means to manage the console of KVM switch. If you select
" CONSOLE ON ", it means that any user can use the console. If you select
" CONSOLE OFF "(factory default OFF state), it means that any user will not be allowed
to use the console unless you enter the password. When you enter the password
already and pass the KVM switch authentication, the CONSOLE will be set to ON. After
you finish using KVM switch, please don't forget to set up CONSOLE ON state to OFF
state. Besides, if current CONSOLE is ON state and you reset KVM switch, the
CONSOLE will be set up ON state back to OFF state.
CONSOLE ON/OFF, etc...
33 / 92
8/16-Port KVM over IP Switch