Sip Petite 1-Line/2-Line - S2211/S2221 - VTech S1100 User Manual

Installation

SIP petite 1-line/2-line - S2211/S2221

Telephone base installation
The telephone can be adapted to desktop use or mount on a standard telephone wall plate.
Installation option - desktop position
1. Turn the telephone base over with the bottom side facing up. Connect the telephone line cord to the telephone base and route
along the wire duct.
Telephone line jack
2. Position the mounting bracket as shown. Insert the two small tabs of the mounting bracket into the lower slots on the telephone
base. Then press the large tab on the mounting bracket and firmly push it into the upper groove on the telephone base.
3. Install the telephone base as shown below. Then connect the coiled handset cord to the telephone base.
4. Once installed, the telephone begins a four-step initialization and system registration process.
For S2211: (1) The MUTE key and IN USE lights turn on and then go off. (2) The MUTE key flashes. (3) The MUTE key
•
stops flashing. (4) The MESSAGE WAITING LED, MUTE and IN USE lights illuminate for 500ms when initialization and
system registration are successful.
If the system registration fails, the IN USE key blinks twice every second.
the network wall jack with Power over Ethernet (PoE) and connect it back again.
For S2221: (1) The MUTE key and LINE 1 turn on and then go off. (2) The MUTE key flashes. (3) The MUTE key stops
•
flashing. (4) The MESSAGE
system registration are successful.
If the system registration fails, the LINE 1 key blinks twice every second.
the network wall jack with Power over Ethernet (PoE) and connect it back again.
CAUTION:
Use only the supplied Cat-5 network cable. Cat-5 network cable is not designed for use in any other IT devices. Misuse of Cat-5 network cable on
your other IT devices shall be prohibited. To order a replacement, visit our website at www.vtechhotelphones.com or call 1-888-907-2007.
Cat-5 network cable
WAITING LED, LINE 1, LINE 2, CONF and MUTE illuminate for 500ms when initialization and
Wire duct
Network wall jack with Power over Ethernet (PoE)
To reset, disconnect the Cat-5 network cable from
To reset, disconnect the Cat-5 network cable from
14