Installation; Sip Classic Lobby/1-Line/2-Line - S1100/S1210/S1220 - VTech S1100 User Manual

Installation

SIP classic lobby/1-line/2-line - S1100/S1210/S1220

Telephone base installation
1. The telephone comes ready for desktop use. Install the telephone base as shown below.
Cat-5 network cable
2. Once installed, the telephone begins a four-step initialization and system registration process.
For S1100: (1) The MUTE key cavity LED and the
•
cavity LED flashes. (3) The MUTE key cavity LED stops flashing and then the
LEDs illuminate for 500ms when initialization and system registration are successful.
• For S1210: (1) The MUTE key and the
key stops flashing and then the
illuminate for 500ms when initialization and system registration are successful.
• For S1220: (1) The MUTE key and the
key stops flashing and then the
/SPEAKER illuminate for 500ms when initialization and system registration are successful.
and
If the system registration fails, the
from the network wall jack with Power over Ethernet (PoE) and connect it back again.
CAUTION:
Use only the supplied Cat-5 network cable. Cat-5 network cable is not designed for use in any other IT devices. Misuse of Cat-5 network cable on
your other IT devices shall be prohibited. To order a replacement, visit our website at www.vtechhotelphones.com or call 1-888-907-2007.
/SPEAKER key cavity LED turn on and then go off. (2) The MUTE key
/SPEAKER key turn on and then go off. (2) The MUTE key flashes. (3) The MUTE
/SPEAKER key flashes. (4) The MESSAGE WAITING LED, LINE, MUTE and
/SPEAKER key turn on and then go off. (2) The MUTE key flashes. (3) The MUTE
/SPEAKER key flashes. (4) The MESSAGE WAITING LED, LINE 1, LINE 2, CONF, MUTE
/SPEAKER key blinks twice every second. To reset, disconnect the Cat-5 network cable
10
Network wall jack with Power over Ethernet (PoE)
RJ-45 LAN port
/SPEAKER key cavity LED flashes. (4) Both
/SPEAKER