Chapter4 Basic Operation Guide; Power On - Jaycar Electronics DS-8704HI-S User Manual

Chapter4 Basic Operation Guide

4.1

Power on

Note: Please make sure the power supply matches DVR and AC cable
connected correctly. Before switch DVR on, please connect one monitor with VOUT
or VGA interface. Otherwise, you can not see graphic user interface and can not
operate.
If [POWER] lamp is off, please do as following:
Step1: Connect AC cable correctly;
Step2: Switch on the power button on the real panel.
If [POWER] lamp is in red, just press [POWER] button to start DVR.
When DVR is started, [POWER] lamp is in green. On the monitor or VGA display,
DSP and HDD initialization process will be shown.
The first line represents DSP initialization. If the DSP icon is "×", it means that the
DSP is initialized error, please contact administrator at once.
The second line represents HDD initialization. Icons of each SATA HDD are displayed.
If the HDD icon is "×", it means the corresponding HDD is not installed or not detected. If
HDD is not detected, please contact administrator.
Note: If HDD is not installed or not detected, there is "No Disk" text string in
DVR preview screen.
27