How To Use - Makita JN3200 Instruction Manual

How
to use
Pre-lubrication
The cutting line should be pre-lubricated with the following. For mild steel or stainless,
use machine
oil
for
aluminum light oil or
kerosene.
Switch operation
* T o start the tool, simply pull the trigger.
Release the trigger t o stop. For contin-
uous operation without having to keep
your finger on the trigger, just pull the
trigger and then push in the lock button
with your thumb. To stop the tool from
the lock position, simply pull the trigger
again and release it.
Permissible cutting thickness
*The thickness of material to
be
cut de-
pends upon the tensile strength of the
material itself. The groove on the die
holder acts as a thickness gauge. Do not
attempt t o cut any material which will
not fit into this groove.
M a t e r i a l t h i c k n e s s
( k g mm2)
Mild steel
Stain I e s s
Cutting procedure
*Smooth nibbling i s achieved by holding
the nibbler upright and applying gentle
pressure in the cutting direction. For
clean cutting apply oil to the punch
about every 10 meters (32.8 feet) of
a
material cut.
-
Lock button
5