Makita JN3200 Instruction Manual page 6

cutouts
cutouts
can b e done by first opening a
round hole of about 42 mm ( 1 -5/8")
dia.
or more in the material.
Cutting stainless steel
.There
is more vibration when cutting
stainless steel than mild steel. Less vibra-
tion and better cutting is possible by add-
ing another washer (standard equipment)
beneath the die.
.Use the hex wrench provided t o remove
the 2 screws and insert the washer below
the die. Replace screws and tighten se-
curely.
Punch replacement
.Fit
the wrench provided onto the lock
nut and tap the handle lightly with a
hammer t o loosen the nut.
.Then, take off the die holder and use the
wrench provided t o remove the screw to
the left (counterclockwise), now remove
the
punch.
Note : When installing the screw and lock
nut, be sure to tighten securely.
If
they become loose during opera-
tion, the tool may break down.
Loosen
w i t h wrench
Screw
6