SPECIFICATIONS Model JN3201 Max. cutting capacities Steel up to 400 N/mm 3.2 mm / 10 ga Steel up to 600 N/mm 2.5 mm / 13 ga Steel up to 800 N/mm 1.0 mm / 20 ga Aluminum up to 200 N/mm 3.5 mm / 10 ga...
Personal Safety General power tool safety warnings Stay alert, watch what you are doing and use common sense when operating a power tool. WARNING: Read all safety warnings, instruc- Do not use a power tool while you are tired or tions, illustrations and specifications provided under the influence of drugs, alcohol or med- with this power tool.
Power tool use and care Always be sure you have a firm footing. Be sure no one is below when using the tool in Do not force the power tool. Use the correct high locations. power tool for your application. The correct power tool will do the job better and safer at the Do not touch the punch, die or the workpiece rate for which it was designed.
Switch action ► 1. Punch 2. Screw 3. Wrench To install the punch, insert it into the punch holder with ► 1. Switch trigger 2. Lock button its cutting edge facing forward so that the pin in the punch holder fits into the groove in the punch. Install the screw and lock nut.
Use the hex wrench provided to remove the two screws and insert Cutting method the washer below the die. Replace screws and tighten securely. MAINTENANCE CAUTION: • Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. •...
These accessories or attachments are recom- • The die can be sharpened two times. After two mended for use with your Makita tool specified sharpenings, it should be replaced with new in this manual. The use of any other accessories one.