D Xenix® Operations - Tandy DCM-7 Operation Manual

XENIX operations
D
Your DCM-7 is configured to operate with a Tandy 6000 running the XENIX
operating system (Version 3.1 or later). This section will be helpful in ex-
plaining how using the DCM-7 with XENIX differs from operations in other
modes.
Always automatic answer mode
Set the DIP switches as illustrated and power up the DCM-7. From a power-
on condition, the DCM-7 will power up into the call-waiting state and monitor
the telephone line for an incoming call. When DTR (Data Terminal Ready)
is asserted (this happens when log-ins are allowed using the enable command),
the Modem will pick up the call and assume always auto-answer, 10-bit word
operation.
Dial out
Set the DIP switches using the same settings as in always automatic answer
mode operation and power up the DCM-7. Program the Modem to auto-
matically dial a call by using the command:
dialHAYES (
ENTER)
Refer to your XENIX system's documentation for more information on us-
ing a modem with XENIX.
53