List Settings And Related Commands (Tandy) - Tandy DCM-7 Operation Manual

Tand~
protocol ref ere nee
When you correctly respond to the first prompt, the display shows the next
prompt:
RETRY FOR 1-9 TIMES OR CR FOR NO CHANGE =
Here again, only a numbe; in the range 1 to 9 or the
(.ENTER)
key is valid.
The prompt is asking you how many times the DCM-7 should try a telephone
number before exiting the auto-dialer routine. Enter a value of 2 or greater
if you want· it to redial the number.
When your response is acceptable, the DCM-7 will return to the command
receptive mode, ready to accept the next command.
The DCM-7 will look for a valid carrier tone from the remote modem.
If
carrier is not detected within 30 seconds, your DCM-7 gives up and prepares
for the next try.
L, 1 List command
The list command is used to review the current state of the DCM-7.
The screen
shows:
MODE= A
TYPE
=
0
F CD
=
Y
SPKR = Y
ANSW
=
2
DTRY = 1
TEST = N
NUMB=
Table 10. List Settings and Related Commands
Parameter
A (Automatic ), M (Manual)
o
(Ori€Jinate), A (Answer)
Y (On-line), N (Off-line)
Y (Monitor speaker on), N (Monitor speaker off)
1-9
1-9
Y (Self-test on), N (Self-test off)
0-9, T (Touch-tone), R (Pulse), ·p (Pause), -, (,),
space, *,
#
RATE =
s s
(Slow), F. (Fast)
EXIT = OF Hex code for abort character
Related
Commands
M
O,A
G
p
I
I
Q
D
S, F
@
The parameters or settings shown above are defaulted when the Modem is
initially powered up. ·
M, m Manual/ automatic toggle
The M command is used to switch the DCM-7 from its automatic (defaulted)
state to manual state. Each time this command is entered, the value of the
MODE
=
x line on thelisting changes from A (automatic) to M (manual)
and back again, depending on how many times the M command is used.
36