Tandy DCM-7 Operation Manual page 44

Tandy protocol ref ere nee
S, s
Slow dialing speed
The slOw dialing speed command is used to force the DCM-7 to dial any
telephone number with slow timing (RA TE ==
x
line on the listing reads RA TE
== S). Slow dialing speed is the default at power-up. While in slow speed
mode, the Modem pulse dials at 10 pulses per second and touch-tone dials
at 5 digits per .second.
X, x Execute programmed comm.and(s)
This command signals the DCM-7 that programming is completed and it is
time to go ON LINE (off-hook) and execute your fnstructions. When the
X command is received, the Modem will do one of three things:
1. Enter a waiting state and monitor the telephone lines for an incoming
call (auto-answer mode).
2~
Seize the telephone lines and monitor for carrier (if in manual originate
or manual answer mode) or start the dialing sequences (if in auto-originate .
mode).
3. Enter the self-test mode in the TEST= Y condition.
38