Computer Connections; Power Source; Modem-To-Computer Cables - Tandy DCM-7 Operation Manual

Appendix C
Computer connections
The DCM-7 uses the RS-232C standard serial interface cable to connect to
your computer. The table below provides the cable requirement for Tandy
computers. If more detailed information is needed, refer to your computer's
owner's manual.
Table 12. Modem-to-Computer Cables
Computer Cable Catalog No.
Model 1
Model 11/16
Model lll/4/4D/4P/12/16B/16B HD
DT-1/DT-100/100
Tandy 102/200/600/1000/1200/1200HD/2000/6000
Tandy 3000
26-1145
26-4403
26-1408
26-1408
26-1399
1. Plug the appropriate end of the interface cable into the R~-232C stan-
dard DB-25 jack on the rear of the Modem.
2. Plug the other end of the cable into the computer's DB-25 jack.
For the following computers, you'll need option boards which contain an
RS-232C interface to connect your DCM-7. Contact your Radio Shack Com-
puter Center for details.
Computer
Model I
Tandy 1000
Tandy 1200
Power source
Table 13. Computer Option Boards
Board
RS-232C Interface Board with cable
RS-232C Option Board
Captain Multifunction Board
Catalog No.
26-1145
25-1006
25-3061
Insert the AC adapter's plug into the AC power jack on the rear of the
Modem. Plug the adapter into an electrical wall outlet or an approved pow-
er strip.
Be sure to connect the adapter to the Modem before you plug the adapter
into the wall outlet. Otherwise, damage to the adapter could result.
Note: Use the supplied adapter only. Another type of adapter could
damage the Modem.
51