Basic Command Codes (Hayes); Dialing And Answering Command Codes (Hayes) - Tandy DCM-7 Operation Manual

Chapter 3
Table 5. Basic Command Codes
Code Description
AT Attention Code
CR Carriage Return
BS Backspace
+ + +
Escape Codf3
0 On-line
z
Reset
Function
Wakes up the Modem to command receptive
st?te. Starts the command line.
Closes the .command line ?nd executes com-
mands. Register S3 defines the carriage
return character. ·
Edits the command line by deleting charac-
ters one by one. Register S5 defines the
backspace character.
Returns the Modem to command mode from
on-line mode. ·Register S2 defines the escape
code character. s·12 defines the escape code
guard time.
Returns the Modem to on-line mode from
conim?nd mode.
Resets the Modem to default condition.
Table 6. Dialing and Answering Command Codes
Code Description
P Pulse Dia.I
Function
Sets the Modem to originate ? telephonf3 call.
D command par?meters include: 0-9, ( ),
space, *, and
# .
Sets the Modf3m to pulse dialing mode.
T Touch-tone Dial Sets the Modem to touch-tone dialing modf3.
R Reverse Modf3 Automatically changes the Modem to answer
mode ?fter ? call i$. originated.
Pause C?uSe$ the Modem to pause while di?ling.
(comm?) Follows the ?Ccess code. Length of pause is
set by Register SB. ·
; (semicolon)
Returns the Modf3m to comm?nd mode ?fter
dialin9.
A/ Rf3peat Comm?nd Repeat$ the comm?nd line. AT and ENTER
are not nf3cess?ry for this command.
A Answf3r Mode lmmedi?tely Sf3ts the Modem to answf3r mode
without waitin9 for a ringin9 sign?I.
23