Table of Contents
Advertisement
·chapter 3
2. At the Main Menu, select Telecom and change the TELECOM-STATUS
screen io show:
Autodi?I
Mod~m
BAUD Rate
Data Word Length
P?rity
.
Number of Stop Bits
XON/XOFF Flow Control
ASCII Character Filter
Line Feed Filter
Echo (Half Duplex)
R~dial
(
#
of Retries)
Yes
300
8 BITS
NONE
1
BIT
ON
OFF
OFF
OFF
0
3. Select "Yes" for the Autodial Modem status setting and press @.
When the DEFINE MODEM FOR COMPUTER DIALING screen ap-
pears, change the dialing sequence to show:
PAUSE: 2
Pause for 2
second~.
SEND: ATDT
W?ke up and originate ? call using
touch-tone
di~ling.
·
NUMBER
Send number which will
b~
input at
terminal mode.
SEND: "M
S~nd ~M to force the DCM-7 to exe-
cute the commands:
WAITC
Wait for carrier
d~tect
before con-
tinuing.
Note:
If
your telephone system requires pulse, rather than touch- .
tone dialing, change ATDT to ATDP in the first SEND line.
4. Press
(f=12)
twice to return to the TELECOM-STATUS screen after sav-
ing the dialing sequence.
Manual logon
1. Enter terminal mode from the TELECOM-STATUS
scre~n
( (EID ).
2. At the TERMINAL MODE screen, press @ID and type in the telephone
number of the information service, then press
(ENTER ) •
3. After the connection has been made successfully, proceed with thelogon
procedures step by step.
27
Advertisement
Table of Contents
